Finish Drilling All holes and Install Hardware
-Install remaining bolts and hardware.
Note: Make sure U-Bolt remains "level" to keep it from binding.
It may be necessary to "tap" with hammer to seat U-Bolt.
Mounting
Instructions for Bike-Vise: 16 photos with FAQ
click
on pictures to enlarge
Photo 7:
Finish Drilling All holes and Install Hardware
-Install
remaining bolts and hardware.
Note: Make sure U-Bolt
remains "level" to keep it from binding.
It may be necessary to "tap" with hammer to seat U-Bolt.
Photo 8: 
Left Side Reinforcing Plate Installed
-Secure reinforcing
plate with "lock-nuts" (2 nuts per bolt) as shown in photo.
Note: On wood beds thicker than 1" locking nuts cannot be
used.
Photo
9: 
Extend Shaft for Lubrication
-Extend shaft out about ¾
its overall length.
-Remove handle attaching bolt using a10mm
wrench.
-CAREFULLY slide inside tube out of outside tube.
-Do
not loose or drop small bearing pack on end of shaft (see photo).
WHY aren't these threads lubricated at the factory? They are lubricated at the factory, but, you need to know how this is done when you lube it next year AND it is always better to "know" it is greased properly.
Photo
10: 
Lubricate Threaded Shaft and Bearing Pack
-Use a good quality
grease and lubricate shaft and bearing pack.
-Reassemble in the
reverse order and attach handle.
Note: You cannot use too
much grease. Grease annually.